Processing laser engraving machine is to do first diagram (Fig. Engraving of BMP or cutting vector AI / PLT / DXF, etc.), graphics software into the machine, and then set the processing parameters and processing methods, then click download, this pattern corresponding motion data is downloaded to the machine, and then to operate the equipment, complete the graphics processing. As can be seen from this process, laser engraving machine is the graphics-driven approach to achieve processing. Actual production, in order to improve efficiency, produced by the graphics layout the way through the process to achieve the greatest number. Typesetting the merits, is directly related to the level of the final production efficiency, so efficient typesetting article describes two ways to prepare your reference.
(A) Choose directions
Although the design of large format laser engraving machine is rectangular size, box-type structure is longer than the X-axis Y-axis direction, cutting structure is longer than the X-axis Y-axis direction, but in a graphical layout are required in accordance with the X-axis direction to reference , a consistent pattern of the form is about the maximum size and the direction of the X-axis direction is placed under. The reason is that a small load on the X axis, Y-axis of a large load in the X-axis direction can get a good rate value, which will help save time, especially when doing the engraving process must be the longest layout with contour direction consistent with the X-axis direction. So that the laser head in the X-axis for maximum acceleration rate, the processing time most provinces, while short profile direction as the advancing direction of Y-axis step distance.
(B) combined
"Combined" refers to when the shape of the graphic is a rectangular shape or a rectangular shape equivalent effect, the graphic layout instead of using automatic layout tools to achieve, but the employer as a way to make the full version of the graphics. This full-page graphic in the distance between the individual graphics and graphical zero, even as one is, and where only one line is connected, that is, two rectangles share an edge. Thus, laser engraving machine in processing laser only go once, but it is done two graphics cutting, thus saving processing time, thereby increasing processing efficiency, while avoiding the waste of material, do both. The only drawback of this method is the need to manually make the entire layout, automatic typesetting some slower, so it is suitable for use in high-volume situations, once plotted, mass use,